Choosing an industrial motor starts with matching the machine, not just the price. You need a motor that fits the voltage and phase your building supplies, the load it will turn, and the frame the equipment was built for. Getting this wrong can mean a motor that does not start, one that overheats, or one that simply does not bolt up. The two options here show how wide that range can be: one is built for heavy machinery and the other is a fan/trimmer replacement motor.
Quick Verdict
If your application is heavy industrial, the first unit wins. If your application is a fan or trimmer replacement, the second unit is the one to choose. The right match depends on the machine, not just the numbers.
At a Glance
| Motor | Listed price | Relative price | Phase | Voltage/Frequency | Speed | Best for |
|---|---|---|---|---|---|---|
| 1800 RPM 5 HP Electric Motor 184T Frame TEFC 230/460V Severe Duty 3 Phase | $330.95 | Three phase | 230/460V, 50/60 Hz | 1800 RPM | Pumps, compressors, conveyors | |
| YYF96-60-6 60W 110V 60Hz 1.0A Replacement Electric Motor For Fan Or Trimmer | $24.99 | Single phase | 110V, 60 Hz | 1250 RPM | Fan or trimmer replacement |
Where Each Motor Wins
The full-frame motor wins for demanding continuous loads. It is built for severe-duty machinery and has the power, speed, and enclosure to handle equipment that runs steadily. Its higher output and heavier construction make it the motor to plan around when the application is a pump, compressor, or conveyor.
The YYF96-60-6 wins for fan and trimmer replacements. It is a new induction motor with a 6-wire connection, made for the less demanding job of keeping small equipment running. It is the practical choice when the old motor has failed and the job is simply to restore a light-duty machine.
Product Notes
#### 1800 RPM 5 HP Electric Motor 184T Frame TEFC 230/460V Severe Duty 3 Phase
Choose this motor when the machine in front of you is built around a 184T frame and a three-phase supply. It delivers 5 HP at 1800 RPM and runs on either 230V or 460V, so it can be wired into existing three-phase systems. The severe-duty TEFC/IP55 enclosure and 25% overload capacity are the reasons to pick it for pumps, compressors, conveyors, and other continuous loads. The practical limit is the size and weight: at 104 lbs with a 1-1/8 keyed shaft, it is a heavy, substantial component that needs enough room in the equipment. It is not a motor for a 110V single-phase circuit.
#### YYF96-60-6 60watt 110V 60hz 1.0A Replacement Electric Motor For Fan Or Trimmer
For a fan or trimmer that needs a new motor, this is the direct replacement style to look at. The YYF96-60-6 is a 60W induction/asynchronous motor rated for 110V at 60 Hz with a 1.0A draw and 1250 RPM. It is new and uses a 6-wire connection, and the low-wattage single-phase design is the reason to choose it: it keeps small equipment running without forcing you to buy industrial capacity you do not need. The limitation is equally clear: at 60W, it is not meant to start or drive heavy loads, and the 6-wire hookup has to be matched to your existing fan or trimmer wiring.
Final Choice by Use Case
Choose the full-frame motor for continuous industrial duty and for equipment that already has the higher-capacity wiring to support it. Choose the YYF96-60-6 for a fan or trimmer that needs a fresh replacement motor.
