Choosing between a compact 1/4 HP motor and a 2 HP workhorse starts with your electrical supply. One motor here runs on 660V three-phase; the other uses 208-230/460V three-phase. That difference determines which motor can be installed without extra equipment. The Baldor 0962-28 is a 1/4 HP unit rated at 1425 RPM, while the General Electric motor delivers 2 HP at 1800 RPM. Their prices sit $218.20 apart, starting at $176.80 for the General Electric and going up to $395.00 for the Baldor.
Quick Verdict
Pick the 2 HP General Electric motor for more torque, a 56C frame with C-face removable base, and the lower $176.80 price. Pick the Baldor 0962-28 if your facility is wired for 660V and the load is light enough for 1/4 HP.
At a Glance
| Product | Price | Horsepower | Voltage | Speed |
|---|---|---|---|---|
| New Baldor 0962-28 | $395.00 | 1/4 HP | 660V | 1425 RPM |
| 2 HP General Electric Motor | $176.80 | 2 HP | 208-230/460V | 1800 RPM |
Where the Baldor Wins
The Baldor is the only one of the two rated for 660V service, so on a high-voltage three-phase feed it avoids needing a step-down transformer. Its 1425 RPM speed also fits lower-speed rotating equipment.
Where the General Electric Wins
The General Electric motor offers 2 HP, a much higher torque capability, and the lower $176.80 price. The 56C frame with C-face removable base is a common mounting pattern for industrial gearboxes and pumps, and the TEFC enclosure adds protection in dusty or damp environments.
New Baldor 0962-28 Industrial Electric Motor
For a machine that needs only 1/4 HP and already runs on a 660V three-phase supply, this Baldor is the exact match. The motor is new, rated for 1425 RPM, and carries the 0962-28 model designation. If your line voltage is 660V, this motor connects to that supply directly. The trade-off is the price: at $395.00 it costs $218.20 more than the General Electric motor in this head-to-head. The horsepower limit also means it is not built for heavy loads. For lighter rotating equipment, the 1425 RPM rating gives you a slower output without needing additional gear reduction. Choose the Baldor when your voltage is already 660V and your torque requirement stays modest.
2 HP General Electric Motor 3 Phase 56C Frame 1800 RPM TEFC 230 / 460 Volt New
This 2 HP motor brings more muscle for industrial jobs and sits at the lower end of the price scale at $176.80. The 56C frame with C-face removable base supports close-coupled mounting to pumps and gearboxes, while the TEFC enclosure guards against dirt and moisture. At 1800 RPM on 60 Hz, it gives a standard industrial speed and handles 208-230/460V three-phase power. Class F insulation, a 1.15 service factor, and inverter-duty ratings are part of the specification. The limitation is voltage: this motor is not rated for 660V. If all you have is a 660V circuit, it will not connect directly and you would need voltage conversion instead. Choose it for higher horsepower needs on a 230/460V supply.
Final Choice by Use Case
Go with the Baldor 0962-28 when your system already runs on 660V and your load stays inside the 1/4 HP range. Choose the 2 HP General Electric motor when you need 1800 RPM, a 56C frame, and more torque from a 208-230/460V supply. Both are new three-phase motors, so the right pick depends more on your power source and required horsepower than on price alone.
